Technical Data - Husqvarna 336 Operator's Manual

Engine
3
Cylinder volume, cu.in/cm
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at 8 500 rpm, ml/min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Standard bar length, inches/cm
Recommended bar lengths, inches/cm
Usable cutting length, inches/cm
Chain speed at max. power, m/sec
Pitch, inch
Thickness of drive link, inch/mm
Number of teeth on drive sprocket
Type Inch
S36x 3/8"
91VS
H30 0,325"
95VP
34
– English

TECHNICAL DATA

336
2,15/35,2
1,5/38
1,22/31
2 800
1,5/ 9 600
SEM
CD
NGK BPMR 7A
Champion RCJ 7Y
0,02/0,5
Zama
C1Q EL20
0,76/0,36
3-7
0,43/0,2
Automatic
8,4/3,8
13"/33
12-16"/30-41
11-15"/28-38
18,3
0,325"/8,25
0,050"/1,3
7
1
5
Inch/mm Inch/mm
0,050"/1,3 5/32" /4,5
0,050"/1,3 3/16" /4,8
RECOMMENDED CUTTING EQUIPMENT
FOR CANADA
The following is a list of recommended cutting equipment
for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all
requirements outlined in the CSA Z62.1-95 Chainsaws and
Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you
may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose
guide bars of the same pitch and having the same number
of sprocket teeth may be considered to have equivalent
kickback energy.
A hard nose bar having the same length and nose radius
as a sprocket-nose bar may be considered to have
equivalent or less kickback energy than the sprocket-nose
bar.
We recommend that you as replacement use the listed bars
and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Guide bar
Length Pitch
inch inch
12 3/8
14 3/8
16 3/8
13 0,325 10T
15 0,325 10T
16 0,325 10T
Angle Angle
60° 30°
60° 30°
Saw chain
Max nose
radius
9T Husqvarna S36x or Oregon 91VS
9T
9T
Husqvarna H30 or Oregon 95VP
Angle Inch/mm
0° 0,025"/0,65
10° 0,025"/0,65
L
Inch/cm: dl
12"/30:45 14"/34:52
16"/41:56
13"/33:56 15"/38:64
16"/41:66