ENGLISH
Using the Timer
Play
Function
Also refer to the operating Instructions of the audio timer
DCD-CX3 (This unit)
Troubleshooting
o
======,
0 0 0 0
If
a problem should arise. first check the following:
1.
Are the connections correct
1
2.
Is the set being operated as described in the operating instructions
1
3.
Are the other components operating property
1
If this unit does not operate properly, check the items listed in the table below. Should the problem persist. there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
i
>
;:;;'/;j",
'I; .
i'
~vmPtotT"\Y
,., .
t;;.,~,jl"£\.:
.i·>·Ca~
>:";,
' c '
;;\
I)"
>i.
e
<
.~res,.·.
;'j; . . ',
Paae
Disc tray does not open.
• The power is not on.
• Turn on the power.
8
.. NO DISC" is displayed even
• The disc is not properly loaded.
• Reload the disc.
3
though a disc is loaded.
"00 : 00" is displayed even
• A disc other than a CD or Super Audio CD • Load a CD or Super Audio CD.
3
though a disc is loaded.
is loaded.
Playback does not start even when • The disc ;s dirty or scratched.
• Wipe the dirt off the disc or replace the
3
the
~!l1
button on the main unit
disc.
or the
~
button on the remote
control unit is pressed.
No sound is produced or sound is
• The output cables are not properly • Check the connections.
7
distorted.
connected to the receiver.
• The
receiver's
function
setting
or • Check the receiver's function and controls
-
adjustments are not right.
and adjust as necessary.
No digital signals are output.
• For Super Audio CDs, no digital signals • For Super Audio CDs, use the analog audio
7
are output.
output signals.
• Turn the pure direct mode on.
• Turn the pure direct mode off.
9
A specific section of the disc
• The disc is dirty or scratched.
• Wipe the dirt off the disc or replace the
3
cannot be played properly.
disc.
Programmed playback is not
• The tracks have not been programmed • Program properly.
9,10
possible.
properly.
A CD-R or CD-RW disc cannot be
• The disc has not been finalized.
• Finalize the disc then play it.
2
played.
• The recording conditions are bad or the • Use a properly recorded disc.
2
quality of the disc itself is poor.
Files recorded in MP3 orWMA
• You have selected a copyright-protected • Press the
~
or
~
button to select a
11
format cannot be played.
WMA file or a file that cannot be played
different file.
normally.
Set does not operate properly
• The batteries are spent.
• Replace the batteries with new ones.
4
when remote control unit is
• The remote control unit is too far from the • Move the remote control unit closer to the
4
operated.
set.
set.
0000
AC outlet (wall)
o
Receiver
o
0
@
Audio timer
1
Tum
on the power of the connected components.
3
Load a disc in the player.
2
Switch the receiver's input function to the function to
which the player is connected.
4
Set the audio timer for the desired times.
5
Tum
the timer ''ON''.
The power of the components connected to the timer turns off.
*
When the set time is reached, the power of the different
components automatically turns on and playback starts from the
first track.
13