Hitachi 46EX1B Service Manual page 11

Perform the following when the HV connector (anode con-
nector) is removed or inserted for CPT replacement, etc.
Anode
connector
Deflection F!W.B.
FBT
Fig. 5
During Removal
1. Insert a small flat-bladed screwdriver (adjustment
screwdriver : 5-7 mm wide and 0.2-0.3 mm thick) into sec-
tion @ in Fig. 6 then push it in the direction of arrow
0
B . The lock will release with a click. (The state in
Fig. 841) will change to that in Fig. 8-(2).)
Anode connector
HV cap
Fig. 6
2. Remove the HV cap and remove the anode connector
(Fig. 7).
- HV cap
1 46EXlB
CAUTIONS WHEN CONNECTING/DISCONNECTING THE HV CONNECTOR
Anode connector
Fig. 7
During Insertion
1. Insert the anode connector deep into the FBT (to sec-
tion @ in Fig. 7) and then push the HV cap into the
FBT until it clicks.
2. Make sure the connector is securely inserted. (Check
that the claw is at the mark on the HV cap shown as in
Fig. 8-(l).)
(1) Lock on
(when connector is inserted)
(2) Release
(when connector is iemoved)
Fig. 8
-1%