Cub Cadet 3X 30 TRAC Operator's Manual page 9

6. Insert the flex shaft into the chute control rod coupling
under the dash panel. See Figure 3-8.
Figure 3-8
7. Remove the cotter pin and washer from the ferrule on the
end of the shift rod. See Figure 3-9 inset.
Figure 3-9
8. Insert the ferrule into the top hole of the shift lever and
secure with the cotter pin and washer removed in the
previous step.
9. Check that all cables are properly routed through the cable
guide on top of the engine.
Set-Up
Shear Pins Storage
Replacement auger shear pins and bow tie cotter pins are
included with your snow thrower. Store them in your snow
thrower's dash panel until needed. See Figure 3-10.
Figure 3-10
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Figure 3-11.
Figure 3-11
S
ection
Chute Clean-Out
Tool
3 — A & S -U
SSembly et p
9