Cub Cadet 3X 30 TRAC Operator's Manual page 8

5. Reattach the two carriage screws and lock nuts removed
earlier as shown in Figure 3-4.
6. Finish securing the handle by tightening the top two lock
nuts loosened earlier. Remove and discard any remaining
rubber bands, if present. They are for packaging purposes
only.
Chute Assembly
1. Remove the lock nuts and hex screws from chute support
bracket. Position the chute assembly over the chute base.
See Figure 3-5.
1
2
8 S 3— A
ection SSembly
Figure 3-4
2
1
Figure 3-5
& S -U
et p
2. Place chute assembly onto chute base.
3. Secure chute control head to chute support bracket with
the lock nuts and hex screws removed earlier.
See Figure 3-6.
Figure 3-6
4. Remove the hairpin clip from the rear of the chute control
assembly.
5. Insert flex shaft removed earlier from the lower handle
into rear of the chute directional control head. Secure the
flex shaft to the chute control head with the hairpin clip
removed earlier. See Figure 3-7.
Figure 3-7