Acer 5540 Series Service Manual page 82

Error Message List
Error Messages
Real time clock error
Previous boot incomplete - Default configuration
used
Memory size found by POST differed from
CMOS
Diskette drive A error
Incorrect Drive A type - run SETUP
System cache error - Cache disabled
CPU ID:
DMA Test Failed
Software NMI Failed
Fail-Safe Timer NMI Failed
Device Address Conflict
Allocation Error for device
Failing Bits: nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
Operating system not found
76
FRU/Action in Sequence
RTC battery
Run BIOS Setup Utility to reconfigure system time, then reboot
system.
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Run "Load Default Settings" in BIOS Setup Utility.
DIMM
System board
Check the drive is defined with the proper diskette type in BIOS
Setup Utility
See "External Diskette Drive Check" on page 70.
Check the drive is defined with the proper diskette type in BIOS
Setup Utility
System board
System board
DIMM
System board
DIMM
System board
DIMM
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
DIMM
BIOS ROM
System board
None
BIOS ROM
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Enter Setup and see if fixed disk and drive A: are properly identified.
Diskette drive
Hard disk drive
System board
Chapter 4