Table of Contents
Advertisement
Ignitor Lighting
s
Do not lean over grill while lighting.
1.
Open lid during lighting.
2. To ignite any burner, turn burner knob to
ROTARY IGNITOR button rapidly.
3. If ignition does NOT immediately take place, turn all burner
valve knobs to
OFF
, wait 5 minutes, then repeat lighting
procedure.
After Lighting warm up on HI
Match Lighting
s
Do not lean over grill while lighting.
1.
Open lid.
Turn on gas at gas source.
2. Attach match to Match holder, light match.
3. Push in and turn any burner to
lights and stays lit. Repeat on other burner.
After Lighting warm up on HI.
Left side of Grill
Match lighting hole
CAUTION
• If burner does not light, turn knobs to OFF. Wait 5
minutes and try again. If the burner does not ignite with
valve open, gas will continue to flow out of the burner
and could accidently ignite with risk of injury.
Burner Flame Check
• Light burner, rotate knobs
from HIGH to LOW. You
should see a smaller flame in
LOW position than seen on HIGH. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop or
Troubleshooting Section
low flame" in the
Turning Grill Off
• Turn all knobs to OFF position. Turn gas OFF at gas source.
Ignitor Check
• Turn gas off at gas source.
"Click" should be heard and spark seen each time between
collector box or burner and electrode. See
no click or spark.
Turn on gas at gas source.
HI, turn
HI. Be sure burner
.
Rotate ignitor button rapidly.
"Troubleshooting"
Valve Check
• Important: Make sure gas is OFF at gas source before
checking valves
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
to
OFF
position. Valves should turn smoothly.
Hose Check
•
Before each use, check to see if hose is cut or worn. Replace
damaged hoses before using grill. Use only valve and hose
specified by manufacturer.
Clean burner prior to use after storing, at the beginning
of the grilling season or after a period of one
month not being used. Spiders and insects
like to build nests in burner tubes
(especially during colder months).
These nests can cause fires in
burner tubes or under grill.
See following pages for specific
cleaning instructions.
General Grill Cleaning
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
(and should never be painted)
solution of detergent and water or use a grill cleaner with
scrub brush to insides of grill lid and bottom. Rinse and allow
to completely air dry.
cleaner to painted surfaces.
•
Plastic parts: W
s
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
HIGH
failure of parts can result.
LOW
• Porcelain grate:
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring
powder for stubborn stains.
• Stainless Steel:
cleaner and warm soapy water, wipe dry with a soft
nonabrasive cloth
if
. Knobs lock in OFF position. To check
LOW
position then turn back
CAUTION
Typical spider webs
inside burner
. Apply a strong
Do not apply a caustic grill/oven
ash with warm soapy water and wipe dry.
Because of glass-like composition, most
Wash with mild detergent or nonabrasive
4638234 • 13
Advertisement
Table of Contents
