Bosch DH1020VC Operating/Safety Instructions Manual page 8

BM 1609929X76 07-12_1609929X76 07-12.qxp 8/1/12 8:00 AM Page 8
AUxILIARy HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen the
2
KNOB
INSTALLING ACCESSORIES
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the tool holder through
the dust shield, while twisting and pushing
inward until it locks automatically into place.
Pull outward on the accessory to be certain it is
locked into the tool holder (Fig. 4).
NOTE: The high efficiency available from the
hammers can only be obtained if sharp and
undamaged accessories are used. The "cost"
to maintain sharp
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING ACCESSORIES
Accessories may be hot after
WARNING
use. Avoid contact with skin
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 5).
Assembly
AUXILIARY
1
HANDLE
3
and undamaged
knob, move the handle to the desired position
along the barrel and securely retighten the
knob (Fig. 3).
FIG. 3
FIG. 4
5
3
4
FIG. 5
1
2
-8-
2
LOCKING
SLEEVE
DUST SHIELD