Warm Engine - Jonsered GT2125 Operator's Manual

Warm engine

Ignition: Set the stop switch to the start position.
Choke: Set the throttle to the start position by moving the
choke control to the choke position and then returning it to its
original position.
Air purge: Press the air purge diaphragm repeatedly until
fuel begins to fill the diaphragm. The diaphragm need not be
completely filled.
Stopping
Stop the engine by switching off the ignition.
WARNING! When the engine is started with
!
the choke in either the choke or start throttle
positions the cutting attachment will start to
rotate immediately.
STARTING AND STOPPING
Starting
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter handle,
slowly pull out the cord with your right hand until you feel
some resistance (the starter pawls grip), now quickly and
powerfully pull the cord. Never wrap the starter cord around
your hand
Reset the choke control as soon as the engine fires and
repeat until the engine starts. When the engine starts, quickly
apply full throttle; the throttle will automatically disengage
from the start setting.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
– 19
English