Husqvarna K 760 Operator's Manual page 20

• Pull the cord out about 30 cm and lift it into the cut-out in
the periphery of the starter pulley. When the cord is intact:
Release the spring tension by letting the pulley rotate
slowly backwards.
• Remove any remnants of the old starter cord and check
that the return spring works. Insert the new starter cord
through the hole in the starter housing and in the cord
pulley.
Secure the starter cord around the cord pulley as illustrated.
Tighten the fastening well and ensure that the free end is as
short as possible. Secure the end of the starter cord in the
starter handle.
Tensioning the recoil spring
• Guide the cord through the cut-out in the periphery of the
pulley and wind the cord 3 times clockwise around the
centre of the starter pulley.
• Now pull the starter handle and in doing so tension the
spring. Repeat the procedure once more, but this time
with four turns.
• Note that the starter handle is drawn to its correct home
position after tensioning the spring.
• Check that the spring is not drawn to its end position by
pulling out the starter line fully. Slow the starter pulley with
your thumb and check that you can turn the pulley at least
a further half turn.
20 –
English
MAINTENANCE
Changing a broken recoil spring
• Undo the bolt in the centre of the pulley and remove the
pulley.
• Bear in mind that the return spring lies tensioned in the
starter housing.
• Loosen the bolts holding the spring cassette.
• Remove the recoil spring by turning the starter over and
loosen the hooks, with the help of a screwdriver. The
hooks hold the return spring assembly on the starter.
• Lubricate the recoil spring with light oil. Fit the pulley and
tension the recoil spring.
Fitting the starter
• To fit the starter, first pull out the starter cord and place the
starter in position against the crankcase. Then slowly
release the starter cord so that the pulley engages with
the pawls.
• Tighten the screws.