Sony CMD-C1 Service Manual page 7

5. Push the hook release jig gently to the lower side,
while holding the CMD-C1. In this way the hook
release jig is used as a lever. More clamps
between upper and lower case will now release
and the parts can be taken out.
7. The display unit can be lifted out. The LCD is
connected with a flex cable and the LCD support
is clamped onto the main board (2 clamps left and
right side).
9. Unsolder the antenna on the right side. The patch antenna assy can now be lifted off. fIt should be
considered as one non-serviceable and sensitive item.
6. The front cosmetic and back cosmetic can now be
separated, and the main board can be taken out.
8. Remove 6 screws located on the display side to
release the patch antenna.
7