Polarization Instructions - Dyson Slim Instructions Manual

18689_CAN_DC18_OP_MAN 19/9/07

Polarization instructions

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
Assembly
Ensure the wand cap cover is closed.
Ensure hose is straight when inserting wand.
Usage and carrying
Caution
This machine is intended for domestic use only. Fine dust, such as plaster dust or flour,
should only be vacuumed in very small amounts.
Use the carry handle to lift the machine.
Do not press the cyclone release button while carrying the machine or it could fall and
cause injury.
Ensure the cyclone is secured to the machine.
Do not shake the machine while carrying or it could fall and cause injury.
Keep hair and loose fabrics away from wand cap when machine is on.
When finished cleaning, push machine into an upright position to drop stabilizers.
Ensure wheels are fully locked in place before releasing the cleaner.
Brushbar control
The brushbar will re-set to "ON" each time you start the machine and put it in the
cleaning position.
To turn the brushbar off, put the machine in the cleaning position and press the brushbar
on/off button.
Use machine in bare floors mode for bare or delicate flooring, rugs, and carpets.
Ensure the machine is in an upright position before adjusting the setting.
The brushbar will automatically stop if it becomes obstructed.
If the brushbar stops during use, please refer to the blockages section.
Consult your flooring manufacturer's recommended instructions before vacuuming and
caring for your flooring, rugs, and carpets. Some carpets will fuzz if a rotating brushbar is
used when vacuuming. If this happens, we recommend vacuuming in bare floors mode
and consulting with your flooring manufacturer.
TIP: The brushbar will not turn until you tilt the handle backwards to begin vacuuming.
Wand release/Using tools
Ensure machine is in upright position before using tools.
To protect your floors, the brushbar will not rotate when the machine is in an upright
position.
Ensure hair and loose clothing are kept clear of wand cap when machine is switched on.
Ensure wand cap is closed, unless using with tools.
Powerful suction can cause the hose to 'pull back' – please take care when cleaning stairs.
To avoid personal injury and to prevent the machine from falling when cleaning stairs,
always place it at the bottom of the stairs.
Do not use your vacuum cleaner outdoors or on wet surfaces.
09:18 Page 3