Saw Chain Filing And File Gauges - Husqvarna 570 Operator's Manual

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Length, inches Pitch, inch Gauge, inch Max. nose radius
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
Saw chain filing and file gauges
40 –
Canadian
TECHNICAL DATA
Bar
0,058 11T
0,058
0,058
0,058
0,058
0,050
0,050
0,050
0,050
0,050
Chain
Type Drive link count
Husqvarna H42, 60
Husqvarna H48
68
72
84
92
Husqvarna H46, 60
Husqvarna H47
68
72
84
93