Vivotek VS2402 User Manual page 24

First access to Video Server in null modem mode
After successful authentication, administrators should see the motion pictures in the
main page. When using Microsoft Internet Explorer, administrators must allow installing
a plug-in provided by Video Server additionally prior to viewing motion pictures.
Change initial password of administrator
For best security, administrators must change the password on the security page of
configuration immediately. After changing the password, the browser will display the
authentication window again to confirm the new password.
Manage user privilege
Administrators can add up to twenty user profiles in the Security option. While Video
Server accepts dial-in connection and acts as a server, the user name and password used
in dialing are the same as what is stored in the user database managed for web access.
Any managed user can be authorized during PPP negotiation and access web pages.
However, only administrators can access the configuration page.
Complete network settings
Basically the null modem is used to setup the later attached modem where Ethernet is
not available. Refer to the modem setting in the COM2 section for details about ISP
information. After everything is set and saved, turn off Video Server and replace the null
modem cable with modem for dial-up network. Since the null modem connection is used
to configure Video Server in advance for modem connection, administrators cannot
connect again without restarting the system.
Through direct connection by null
modem cable, administrators can
connect to "http://200.1.1.1" in
the web browser. "200.1.1.1"
will be the default IP address of
Video Server in dial-in connection;
"200.1.1.100" will be the given
IP address for the user's PC by
Video Server. The user name and
password are the same as what
was
installation.
- 21 -
entered during software