Table Of Contents; Basic Specifications - JBL Northridge E150P Service Manual

E150P
BASIC SPECIFICATIONS ......................................1
SAFETY INFORMATION
DETAILED SPECIFICATIONS ................................3
CONNECTIONS....................................................4
OPERATION ........................................................7
BASIC TROUBLESHOOTING.................................8
EXPLODED VIEW/PARTS LIST...............................9
TEST SET-UP AND PROCEDURE..........................10
AMPLIFIER BLOCK DIAGRAM...............................11
TECH TIP JBLTT2003-04 .....................................12
DETAILED TROUBLESHOOTING.................... ......13
P.C.B. DRAWINGS...............................................16
ELECTRICAL PARTS LIST ...................................20
IC/TRANSISTOR PINOUTS.....................................24
SCHEMATICS.....................................................25
PACKING...........................................................27
E150P SPECIFICATIONS
Amplifier Power (RMS):
Peak Dynamic Power *:
Driver:
Inputs:
Low-Pass Frequency:
Frequency Response:
Dimensions (H x W x D):
Weight:
JBL continually strives to update and improve existing products, as well as create new ones. The
specifications and details in this and related JBL publications are therefore subject to change without
notice.
The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of a resistive load
*
equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
- CONTENTS -
.......................................2
150 Watts
250 Watts
10" (254mm) PolyPlas™
Line Level (switchable to LFE) and Speaker
Level with 5-way binding posts
Variable from 50Hz to 150Hz
27Hz - Low-pass crossover setting
17-3/4" x 12-1/4" x 14-1/2"
(451mm x 311mm x 368mm)
33.5 lb/15.2kg
1