Table of Contents
Advertisement
EN
The oil level must never exceed the "FULL" mark.
This results in the engine overheating. If the oil
level exceeds the "FULL" mark, the oil must be
drained until the correct level is achieved.
4.3 Safety checks
Check that the results of the safety checks below
are achieved when testing the machine in question.
The safety checks must always be car-
ried out every time before use.
If any of the results below is not
achieved, the machine must not be
used! Take the machine to a service
workshop for repair.
4.3.1 General safety check
Object
Result
Fuel lines and con-
No leaks.
nections.
Electrical cables.
All insulation intact.
No mechanical damage.
Exhaust system.
No leaks at connections.
All screws tightened.
Oil lines
No leaks. No damage.
Drive the machine
The machine will stop.
forwards/back-
wards and release
the driving-service
brake pedal.
Test driving
No abnormal vibrations.
No abnormal sound.
4.3.2 Electrical safety check
The operation of the safety system
should always be checked every time
before use.
Status
Action
The clutch-brake
Try to start.
pedal is not
depressed.
The power take-off
is not activated.
The clutch-brake
The driver gets up
pedal is depressed.
from the seat.
The power take-off
is activated.
Engine running.
The driver gets up
The power take-off
from the seat.
is activated.
Engine running.
Remove fuse 10
A.
See fig. 13.
68
ENGLISH
Status
Cruise control acti-
vated.
Cruise control acti-
vated.
The switch for the
implement lifter is
in neutral position.
(not Pro16)
4.4 Start
1. Open the fuel cock. See 14.
2. Check that the spark plug cable(s) is/are in-
stalled on the spark plug(s).
3. Check to make sure that the power take-off is
disengaged.
4. Do not keep your foot on the drive pedal (3:F).
5. Put the throttle control at full throttle.
Starting cold engine – pull the choke control out
fully.
Starting warm engine – the choke control
should be pressed in.
6. Depress the clutch-brake pedal (3:B) fully.
7. Turn the ignition key and start the engine.
8 Once the engine has started, push the choke
control in gradually if it has been used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the
engine run for a few minutes first. This will al-
low the oil to warm up.
When the machine is in operation, full throttle
should always be used.
4.5 Power assisted steering
(Pro20, Pro25, Pro Svan)
Result
Power assisted steering means that power from the
The engine
machine's hydraulic system is supplied to the
will not start.
steering wheel movements. This makes the ma-
chine very easy to steer when the engine is operat-
ing at working revs (full throttle).
The servo effect is reduced as the engine speed
The engine
drops.
will not start.
4.6 Operating tips
Always check that there is the correct volume of
The power
oil in the engine. This is particularly important
take-off will
when operating on slopes. See 4.2.
be disen-
gaged.
The engine
will stop.
Action
Result
The driver gets up
The cruise
from the seat.
control will
be disen-
gaged.
The clutch-brake
The cruise
pedal is depressed.
control will
be disen-
gaged.
Try to engage the
It will not be
power take-off.
possible to
engage the
power take-
off.
Hide quick links:
Advertisement
Table of Contents
