Makita BHP456 Instruction Manual
Cordless hammer driver drill
Hide thumbs
Also See for BHP456:
- Instruction manual (56 pages) ,
- Instruction manual (57 pages) ,
- Instruction manual (10 pages)
Related Manuals for Makita BHP456
Summary of Contents for Makita BHP456
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill BHP446 BHP456 011491 IMPORTANT: Read Before Using.
-
Page 2: Specifications
Do not dispose of electric equipment or Li-ion The noise level under working may exceed 80 dB (A). battery pack together with household waste material! Model BHP456 In observance of European Directive 2002/96/EC on waste electric and Sound pressure level (L ) : 81 dB(A) -
Page 3: General Power Tool Safety Warnings
Makita Corporation responsible Keep children and bystanders away while manufacturer declare that the following Makita operating a power tool. Distractions can cause machine(s): you to lose control. Designation of Machine: Electrical safety Cordless Hammer Driver Drill Power tool plugs must match the outlet. - Page 4 a cord suitable for outdoor use reduces the risk of preventive safety measures reduce the risk of electric shock. starting the power tool accidentally. If operating a power tool in a damp location is 20. Store idle power tools out of the reach of unavoidable, use a ground fault circuit children and do not allow persons unfamiliar interrupter (GFCI) protected supply.
- Page 5 GEB056-4 using battery. Do not disassemble battery cartridge. CORDLESS HAMMER DRIVER If operating time has become excessively DRILL SAFETY WARNINGS shorter, stop operating immediately. It may result in a risk of overheating, possible burns Wear ear protectors with impact drilling. and even an explosion.
-
Page 6: Functional Description
When the tool is overloaded: • FUNCTIONAL DESCRIPTION At this time, release the switch trigger, remove the battery cartridge and remove causes of overload and then pull the switch CAUTION: trigger again to restart. Always be sure that the tool is switched off and the •... -
Page 7: Reversing Switch Action
NOTE: Selecting the action mode Use a dry cloth to wipe the dirt off the lens of the • lamp. Be careful not to scratch the lens of lamp, or it 1. Action mode changing ring may lower the illumination. 2. -
Page 8: Screwdriving Operation
it may accidentally fall out of the tool, causing injury Installing or removing the driver bit or drill bit to you or someone around you. Hold the tool firmly with one hand on the grip and the 1. Sleeve other hand on the bottom of the battery cartridge to control the twisting action. -
Page 9: Drilling Operation
Then proceed as follows. Drilling in metal Place the point of the driver bit in the screw head and To prevent the bit from slipping when starting to make a apply pressure to the tool. Start the tool slowly and then hole, make an indentation with a center-punch and increase the speed gradually. -
Page 10: Optional Accessories
Only use the accessories or attachments for their stated purposes. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Drill bits • Tungsten-carbide tipped hammer bit •... - Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 885029-221...