Table of Contents
Advertisement
STEP 9 POSITION DISHWASHER UNDER COUNTERTOP
• Check to be sure that wires are secure under the
dishwasher and not pinched or in contact with door
springs or other dishwasher components.
• Push dishwasher into cabinet. The front corners of the
dishwasher door should be flush with cabinet doors.
Be careful not to dent front panel with knees or
damage countertop or cabinets with dishwasher
parts.
• Carefully open and close the door to ensure that the
door panel does not catch or rub on the cabinet frame.
• If the door catches or rubs on the frame, reposition
and/or level the unit (see Step 10) until the door moves
freely and does not contact the cabinet frame.
NOTE: If the drain hose gets trapped between the
wall and the back side of the dishwasher, it can prevent
the dishwasher from sliding all the way back into the
cabinet opening, and thus preventing a flush fit with
the kitchen cabinet panels.
NOTE: If this dishwasher is replacing an existing
dishwasher, the old countertop bracket screw holes
may not be in the correct position. New holes may be
required.
STEP 10 LEVEL DISHWASHER
IMPORTANT
be level for proper dish rack operation and wash
performance.
• Place level on
door and rack
track inside the
tub as shown to
check that the
dishwasher is
level.
Figure T
Installation Instructions
–
Dishwasher must
Check
Level
Check
Front
Level
to Back
Side
To Side
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
Figure S
• Level the dishwasher
by adjusting the
four leveling legs
individually.
TIP: Pull lower rack out, about halfway. Check to be sure
the rack does not roll forward or back into dishwasher.
If the rack rolls in either direction, the dishwasher must
be leveled again.
• If door hits the tub, the dishwasher is not installed
correctly. Adjust leveling legs to align door to tub.
11
Reposition Dishwasher
by Grasping Both
Sides With Hands
Turn Legs
to Adjust
Figure U
Advertisement
Table of Contents
