Remote-A Or B Selection - Toshiba RAS-B10UFV-E Service Manual

Item
To separate using of remote control for each indoor
17. Remote-A or B
selection unit in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1) Press RESET button on the indoor unit to turn
the air conditioner ON.
2) Point the remote control at the indoor unit.
3) Push and hold CHK • button on the Remote
Control by the tip of the pencil. "00" will be shown
shown on the display.
4) Press MODE • during pushing CHK • . "B" will
show on the display and "00" will disappear and
the air conditioner will turn OFF. The Remote
Control B is memorized.
Note : 1. Repeat above step to reset Remote Control
Indoor Unit B Setup.
1) Press and hold [Mode] button for more than
20 seconds.
2) After holding 20 seconds, the air conditioner
beep 5 times, without any blinking of display.
3) After releasing [Mode] button, Indoor Unit B is set.
Note :
1. After holding 10 seconds, the air conditioner
2. Repeat above step to reset Indoor Unit A.
Operation flow and applicable data, etc.
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
beep 4 times, but continue to hold [ Mode] button.
After holding 20 seconds, the airconditioner
beep 5 times and operation display blinks for
5 seconds.
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents the
remote controll signal from being
received simultaneously by both units,
thus preventing both units from operating.
3. Operation
The indoor unit on which the remote
controll selection has been set to B
receives the signal of the remote control
also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
− −
49
Description