GE PGS908 Owner's Manual page 89

Problem Possible Causes
"F—and a number You have a function error code. • Touch the CLEAR/OFF pad. Put the oven back into
or letter" flash
in the display
If the function code repeats.
Control signals after
You forgot to enter a
entering cooking time
bake temperature or
or start time cleaning time.
Display goes blank
A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Display flashes
Power failure.
Unable to get the
Oven control pads were
display to show "SF"
not touched properly.
"Probe" appears in
This is reminding you to
the display
enter a probe temperature
after plugging in the probe.
Power outage,
Power outage or surge.
clock flashes
Steam from the vent
When using the convection
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily" This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time.
the vent
Strong odor An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan or a convection • This is normal. The cooling fan will turn off and
fan (depending on the
function you are using) may
automatically turn on and off.
LOC shows in the The Range Lock-Out feature • Be sure the surface burner controls are turned OFF.
display
is activated.
What To Do
operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Touch the BAKE pad and desired temperature or
the SELF CLEAN LO/STD pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BROIL HI/LO and BAKE pads must be touched at
the same time and held for 3 seconds.
• Enter a probe temperature.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• This is normal.
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
on to cool internal parts. It may run after the oven is
turned OFF. The convection fan will cycle on and off
until the function is over or the door is opened.
Turn this feature off to use the range. See the
Range Lock-Out section.
ge.com (U.S.)
www.GEAppliances.ca (Canada)
41