Alto Filtra-Vac 14 Operator's Manual
Hide thumbs Also See for Filtra-Vac 14:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

E
FILTRA-VAC
Operator's
Manual
14 & 18
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your Clarke
Technology machine could result in injury to you or to other personnel; damage to the machine or to
other property could occur as well. You must have training in the operation of this machine before
using it. If you or your operator(s) cannot read English, have this manual explained fully before
attempting to operate this machine.
Si Ud. o sus operadores no pueden leer el Inglés, se hagan explicar este manual completamente antes
de tratar el manejo o servicio de esta máquina.
All directions given in this book are as seen from the operator's position at the rear of the machine.
For new books write to: ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764.
Form No. 78598A
3/01
CLARKE TECHNOLOGY
Printed in the USA

Advertisement

Table of Contents
loading

Summary of Contents for Alto Filtra-Vac 14

  • Page 1 All directions given in this book are as seen from the operator’s position at the rear of the machine. For new books write to: ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764. Form No. 78598A...
  • Page 2: Table Of Contents

    Parts List #1 Tank Assembly ......................31 Drawing #2 Head Assembly ......................32 Parts List #2 Head Assembly ......................33 Drawing & Parts List #3 Wand Assembly ..................34 Electrical Schematic ........................Page 2 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 3 Diagrama #2 : conjunto de la cabeza .................... 32 Lista de piezas #2 : conjunto de la cabeza ..................33 Diagrama y lista de piezas #3 : conjunto del tubo de aspiración ............ 34 Diagrama eléctrico ........................35 Filtra-Vac 14 and 18 Operator's Manual Page 3 CLARKE TECHNOLOGY...
  • Page 4 Schéma #2 : ensemble de la tête ......................32 Liste de pièces #2 : ensemble de la tête ....................33 Schéma et liste de pièces #3 : ensemble du tuyau d’aspiration ............34 Schéma électrique ..........................35 Page 4 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 5: Important Safety Instructions

    15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. 16. Connect to properly grounded outlet. See "Grounding Instructions". SAVE THESE INSTRUCTIONS Filtra-Vac 14 and 18 Operator's Manual Page 5 CLARKE TECHNOLOGY...
  • Page 6: Instrucciones De Seguridad Para El Operador

    15. No use la máquina para aspirar los líquidos inflamables o carburantes como la gasolina o en sitios donde este tipo de líquido podría encontrarse. 16. Conecte la máquina sólo con un enchufe con puesta a tierra. Véase las «Instrucciones para la conexión eléctrica». GUARDE CUIDADOSAMENTE ESTAS INSTRUCCIONES DE SEGURIDAD Page 6 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 7 16. "Ne brancher qu'à une prise de courant avec mise à la terre. Voir les instructions visant la mise à la terre." CONSERVER CES INSTRUCTIONS Filtra-Vac 14 and 18 Operator's Manual Page 7 CLARKE TECHNOLOGY...
  • Page 8 6 lt, 2-ply disposable Weight 18 lbs. 18 lbs. Shipping Weight 22 lbs 22 lbs Size 9" x 14" x 41" 9" x 18" x 41" Warranty 1 year 1 year Page 8 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 9: Introducción Y Características Técnicas

    CONSERVEZ SOIGNEUSEMENT CES CONSIGNES DE SECURITE Les modèles Filtra-Vac 14 et 18 sont des aspirateurs verticaux destinés au nettoyage des tapis. Ces machines sont conçues pour l’aspiration de débris secs (aspirateur type «poussière»). Ces machines sont destinées à un usage commercial.
  • Page 10: Grounding Instructions

    A. Compruebe que la máquina esté conectada con una caja de enchufe que tiene la configuración adecuada. No utilice ningún adaptador para conectar esta máquina. Page 10 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 11 A de la figure 2. S'assurer que l'appareil est branché à une prise de courant ayant la même configura- tion que la fiche. Aucun adaptateur ne devrait être utilisé avec cet appareil. Filtra-Vac 14 and 18 Operator's Manual Page 11 CLARKE TECHNOLOGY...
  • Page 12: The Controls

    Figure 2 The Wand (See figure 3) The wand is in the holder in the back of the tank housing. Figure 3 Page 12 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 13 Tuyau d’aspiration (Voir figure 3) Se coloca en el alojamiento encontrándose en la cara Il se range dans le logement situé sur la face arrière du trasera del depósito. réservoir. Filtra-Vac 14 and 18 Operator's Manual Page 13 CLARKE TECHNOLOGY...
  • Page 14 Figure 6 The Cord Storage Hooks (See figure 7) The cord storage hooks are on the back of the tank housing and the handles. Figure 7 Page 14 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 15 (Véase figura 7) Ces crochets se trouvent sur la face arrière du réservoir Estos ganchos se encuentran en la cara trasera del et sur la poignée. depósito y sobre la empuñadura. Filtra-Vac 14 and 18 Operator's Manual Page 15 CLARKE TECHNOLOGY...
  • Page 16: How To Assemble The Machine

    Put the thumbscrew through the hole in the Figure 10 front of the tank housing (2). d. Tighten the thumbscrew. To tighten the thumbscrew, turn it clockwise. See figure 11. Figure 11 Page 16 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 17 (2). d. Serrer la vis en la tournant dans le sens horlogique. d. Apriete el tornillo, girándolo en el sentido de las agujas del reloj. Filtra-Vac 14 and 18 Operator's Manual Page 17 CLARKE TECHNOLOGY...
  • Page 18 10. Put the vacuum hose over the hook on the handle assembly (4). See figure 13. Figure 12 11. Put the power cord around the cord storage hooks (5). See figure 13. Figure 13 Page 18 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 19 11.Enrolle el cable de alimentación sobre los dos ganchos en la parte de atrás del aparato (5). 11. Enrouler le câble d’alimentation sur les deux (Figura 13). crochets à l’arrière de l’appareil (5) (Figure 13). Filtra-Vac 14 and 18 Operator's Manual Page 19 CLARKE TECHNOLOGY...
  • Page 20: How To Operate The Machine

    14. NOTE: The machine comes with a filter bag installed in the tank housing. Use the Filtra-Vac 14 or Filtra-Vac 18 as a carpet cleaner or as an upholstery cleaner. To operate the machine as a Figure 14 carpet cleaner, follow this procedure: 1.
  • Page 21 Les modèles Filtra-Vac 14 ou Filtra-Vac 18 s’utilisent Los modelos Filtra-Vac 14 o Filtra-Vac 18 se usan para pour le nettoyage des tapis ou des meubles recouverts limpiar alfombras o muebles tapizados con tejido. Para de tissu.
  • Page 22: Maintenance

    4. Remove the dirt from the bag. 5. Slide the clamp on the bottom of the filter bag. 6. Install the filter bag in the machine. 7. Close the tank housing. Figure 17 Page 22 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 23: Mantenimiento

    6. Replacez le sac filtre dans la machine. 6. Coloque de nuevo la bolsa-filtro en la máquina. 7. Refermez le couvercle du réservoir d’aspiration. 7. Cierre la tapa del depósito de aspiración. Filtra-Vac 14 and 18 Operator's Manual Page 23 CLARKE TECHNOLOGY...
  • Page 24: How To Clean The Motor Filter

    7. Put the machine on its wheels. WARNING: To reduce the risk of injury from moving parts, unplug before servicing. ATTENTION: Pour ériter d'être blessé pour les piéces en mouvement, débiancher avant la maintenance. Page 24 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 25: Limpieza Del Filtro Del Motor

    à des pièces en mouvement, desconecte la máquina ANTES de efectuar débranchez toujours la machine AVANT cualquier mantenimiento. d’effectuer tout entretien. Filtra-Vac 14 and 18 Operator's Manual Page 25 CLARKE TECHNOLOGY...
  • Page 26: How To Change The Drive Belt

    If the motor draws high amperage, the circuit breaker will stop the motor. If the motor stops, let the motor cool before restarting the machine. If the motor contin- ues to stop, consult an authorized service person. Page 26 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 27: Reemplazo De La Correa De Arrastre

    Si el motor para otra vez, machine en marche. Si le moteur se coupe à nouveau, acude a un técnico cualificado. consulter un technicien qualifié. Filtra-Vac 14 and 18 Operator's Manual Page 27 CLARKE TECHNOLOGY...
  • Page 28 The appliance is now ready for use again. Los modelos Filtra-Vac 14 y 18 son provistos de una correa con entallas (y no plana) y de un sistema electrónico de parada automática del motor del cepillo en caso de sobrecarga.
  • Page 29: Section Ii Parts And Service Manual

    FILTRA-VAC 14 & 18 Section II Parts and Service Manual (78598A) Filtra-Vac 14 and 18 Operator's Manual Page 29 CLARKE TECHNOLOGY...
  • Page 30: Drawing #1 Tank Assembly

    CLARKE TECHNOLOGY Fitra-Vac 14 and 18 Drawing #1 Tank Assembly 1/01 Page 30 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 31: Parts List #1 Tank Assembly

    CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Parts List #1 Tank Assembly 3/01 Ref. Ref. Part No. Description Req’d. Part No. Description Req’d. 52904A Clip 80065A Screw 52779A Washer 52786A Cover 52923A Clip 52927B Handle with Cover 55137B Cable Holder 55658A...
  • Page 32: Drawing #2 Head Assembly

    CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Drawing #2 Head Assembly 1/01 Page 32 Filtra-Vac 14 and 18 Operator's Manual CLARKE TECHNOLOGY...
  • Page 33: Parts List #2 Head Assembly

    CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Parts List #2 Head Assembly 1/01 Ref. Part No. Description Req. 52094A Bracket, Pivot 80071A Insert, Locking 52781B Cover, Brush Motor 55664A Lamp (120V) 44106A Lamp ( 230V) 912311 Switch 56859A Pivot, Handle 58618A...
  • Page 34 CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Parts List #3 Wand Assembly 12/98 Ref. Part No. Description Req. 53054A Swivel End Hose 57405A Spring Ring 59318A Hand Tube 57608A Regulator, Suction 59818A Wand, Black 55141A Hose with Hand Tube 53075A Connecting Socket...
  • Page 35: Electrical Schematic

    CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Electrical Schematic 3/01 Filtra-Vac 14 and 18 Operator's Manual Page 35 CLARKE TECHNOLOGY Filtra-Vac 14 and 18 Operator's Manual Page 35 CLARKE TECHNOLOGY...
  • Page 36 NOTES...
  • Page 37 (501) 750-1000 Customer Service - 1-800-253-0367 SALES SUBSIDIARIES Technical Service - 1-800-356-7274 ALTO Canada Ltd., Rexdale Ontario ALTO U.S. Inc., Bowling Green, Ohio 43402 24 Constellation Ct. 1100 Haskins (416) 675-5830 ALTO U.S. Inc., Clearwater, Florida 33765 ALTO Overseas Inc., Sydney (Australia) 1500 N.
  • Page 38 Clarke Technology product. Return the card to assist Clarke Technology in providing the performance you expect from your new floor machine. ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764. CLARKE TECHNOLOGY reserves the right to make changes or improvements to its machines without notice.

This manual is also suitable for:

Filtra-vac 18

Table of Contents