Replacing Seat Positioning Strap - Invacare At'm Owner's Operator And Maintenance Manual

REPLACING SEAT POSITIONING STRAP

ALWAYS wear your seat positioning strap.
The seat positioning strap is a positioning belt ONLY. It is not designed for use as a
safety device withstanding high stress loads such as auto or aircraft safety belts. If
signs of wear appear, belt MUST be replaced immediately.
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove the locknut that secures one (1) half of the seat positioning strap to the
wheelchair frame.
2. Slide the seat positioning strap half from the wheelchair frame.
NOTE: DO NOT remove the mounting screw.
3. Position one (1) new seat positioning strap half on the mounting screw.
4. Reinstall the locknut that secures the seat positioning strap half to the wheelchair
frame.
5. Repeat STEPS 1- 4 for the other half of the seat positioning strap.
One (1) Half of Seat
Positioning Strap
Wheelchair
Frame
Mounting Screw
NOTE: DO NOT remove the mounting screw.
NOTE: Seat upholstery not shown for clarity.
FIGURE 6.2 - REPLACING SEAT POSITIONING STRAP
Part No. 1125035
WARNING
31
SECTION 6—SEAT
One (1) Half of Seat
Positioning Strap
Locknut
At'm