Assembly; Install Blower Pipes - Echo Power blower Operator's Manual

10
A
SSEMBLY
WARNING
Never perform maintenance or assembly procedures with engine
running or serious personal injury may result.

INSTALL BLOWER PIPES

1. Assemble clamps (A) onto both ends of flexible pipe (B).
2. Assemble swivel pipe (C) into flexible pipe (B).
NOTE
Assure throttle cable is not twisted before installing handle (F).
3. Position cable between the elbow (D) and frame and along the top
of the flexible pipe. Remove clamp screw (E) on handle (F). Align
notch in handle with tabs (G). Spread clamp and install onto swivel
pipe (C) past ridges in pipe.
4. Assemble flexible pipe (B) to elbow (D) on blower and tighten
clamps (A).
NOTE
A light lubricant may be used to ease assembly of flexible pipe to
blower elbow.
5. Install cable tie (H) in second groove of flexible pipe.
6. Move handle (F) to desired position. Tighten knob (I) hand tight
and tighten clamp screw (E).
7. Assemble straight pipe (J) onto swivel pipe (C), until you feel light
resistance. Do not force connection. Hold swivel pipe and turn
straight pipe clockwise, engaging positive locking channels, until
connection is firm. Do not force connection.
8. Assemble straight pipe with decal (K) to straight pipe (J) as in step
7.
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosening
occurs, remove two straight pipes and install according to instruc-
tions 7 & 8.
DANGER
A
B
B
D
H
J
F
C
E
A
F
C
G
E
K