Models 3600 and 3600XL
DETAIL "A"
Burp Fitting
NOTE: Model 3650 shown. Models 3600 and 3600XL have the same contents in the disinfecting cabinet.
Injector
Screw
DETAIL
"C"
FIGURE 4.1 Calibrating the Disinfectant Flow Meter
Troubleshooting
SYMPTOMS
Hydromassage System
System will not start.
System is ineffective.
Tub Operation
No water flow.
Restricted water flow.
NOTE: If problems are not remedied by the suggested means above, contact an ICCI dealer or
technical support.
Part No 1118387
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
Model 3650
Burp Fitting
Disinfectant Valve
Disinfectant Siphon Tube
FAULTS
No electrical power to tub.
System not prepared.
Switch hose disconnected
Water deposits in whirlpool jets. Disassemble and clean whirlpool jets.
Whirlpool jets closed.
Aerator closed.
Whirlpool intake clogged.
Water supply turned off.
RADA valve. Refer to RADA
owner's manual
33
Disinfectant Cabinet Door
DETAIL "B"
Floating
Ball
SOLUTION
Check and reset breaker.
Be sure water level is ABOVE jets.
Check that inlet plug on tub is depressed.
Reconnect hose to switch and motor.
Open whirlpool jets.
Open aerator.
Inspect intake and remove obstruction.
Turn on water supply.
Inspect and clean RADA valve.
Side Entry Whirlpool Tub
Knob
Flow
Meter