SECTION 3—OPERATING INSTRUCTIONS
Operating Shower/Massage Wand
NOTE: For this procedure, refer to FIGURE 3.4.
NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.
1. Turn shower/massage wand on to desired flow by rotating shower On/Off valve
(Detail "A").
2. Adjust water temperature using the water temperature valve while watching the flow
water thermometer (Detail "B").
3. Adjust shower spray by rotating shower wand head (Detail "C").
NOTE: Refer to following chart for shower head adjustment settings.
4. Turn shower On/Off valve to off position when finished.
DETAIL "A"
Shower On/Off Valve
Filling Tub
NOTE: For this procedure, refer to FIGURE 3.5 on page 27.
1. Close the drain (Detail "A").
2. Turn tub fill On/Off valve to on position by rotating valve (Detail "B").
3. Adjust water temperature using the water temperature valve while watching flow
water thermometer (Detail "C").
Before starting hydromassage, water level MUST be completely above whirlpool
jets otherwise severe damage to the motor/pump will result.
4. Turn tub fill On/Off valve to off position when water reaches desired level (Detail "B").
Side Entry Whirlpool Tub
Stream
Shower Spray
Mixture of Spray and Pulse Massage
Pulse Massage
DETAIL "B"
Flow Water
Thermometer
Water
Temperature
Valve
FIGURE 3.4 Operating Shower/Massage Wand
CAUTION
Head
26
DETAIL "C"
Shower/Massage
Wand
Part No 1118387