Installation - AEG Lavatherm 76280AC User Manual

28

INSTALLATION

APPLIANCE POSITIONING
• The tumble dryer must be installed in
a clean position, where dirt does not
collect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance
are not blocked .
• To keep vibration and noise at the
minimum, when the tumble dryer op-
erates, it must be put on a stable and
flat surface.
• When the appliance is put in its per-
manent position, check it is fully level
with the aid of a spirit level. If it is
not, adjust the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through
thick carpets, plank of wood or piece
of wood. This can increase the heat
which can cause interference with the
operation of the appliance.
• The temperature of the hot
• When the tumble dryer oper-
• If it is necessary to move the
• The appliance must not be in-
air insde the tumble dryer can
exceed 60 °C. The appliance
must not be installed on the
floor which is not resistant to
high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
appliance, it must be moved
vertically.
stalled behind a lockable
door, a sliding door, a door
with a hinge on the opposite
side to that of the appliance
in such a way that a full open-
ing of the tumble dryer is re-
stricted.
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
UNPACKING
CAUTION!
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyr-
ene blockages out from the drum.
INSTALLATION UNDER A
COUNTER
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).