Child Lock Function; Starting A Programme - AEG Lavatherm 76280AC User Manual

16
shown on the display (e.g.
the programme has to start after 12
hours.)
3. To activate the Delay start function,
push the Start/Pause button. The
time to start decreases on the dis-
play.

CHILD LOCK FUNCTION

The child lock can be set to prevent
children accidently setting a program.
The child lock function locks all push
buttons and the programme dial (this
function does not lock On/Off button).
To activate the child lock function push
the Dry Plus and Delicate buttons at the
same time until the symbol
into view on the display. To deactivate
push again the above buttons until the
symbol goes out of view.
You can activate the child lock function:
• before you push the Start/Pause but-
ton - the appliance cannot start
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated

STARTING A PROGRAMME

To activate the programme push the
if
Start/Pause button. The LED above the
push button changes the colour to red.
CHANGE A PROGRAMME
To change a programme, push the On/
Off button to deactivate appliance.
Push the On/Off to activate the appli-
ance and then set the programme
again.
AT THE END OF PROGRAMME
When the drying cycle is completed,
the
the Buzzer function is on, an acoustic
signal sounds intermittently for one mi-
comes
nute.
To remove the laundry:
1. Push the On/Off button for 2 sec-
onds to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
symbol flashes on the display. If
After each drying cycle: