Replacing The Battery - Cisco Remote Control Quick Start Manual

3

Replacing the Battery

Whenever it is necessary to replace the lithium battery in your
DMP remote control:
Place the remote control on a flat surface, button-side
Step 1
down.
To unlock the "BATT" clip
Step 2
and remove it, do these two
things simultaneously:
• Pinch the locking
mechanism to unlock it.
• Slide the clip out of the
remote control.
To remove the old battery
Step 3
from the clip, pivot the
battery so that it touches only
the opening of the clip.
Insert a new battery so that positive charge (+) symbols
Step 4
are visible simultaneously on the battery and the clip.
Slide the clip back in to the remote control.
Step 5
8
MUTE
INPUT EXIT
ENTER
VOL CH
MENU
SHOW
IP