Zanussi DE 6854 Instruction Book page 7

Dishwasher
Hide thumbs Also See for DE 6854:
Table of Contents

Advertisement

Filling with rinse aid
(Rinse aid dispenser type B)
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full. The
indicator (B) will be completely dark.
BR01
Ensure that the lid is closed after every refill.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
The dose is factory set in
position 5.
Reduce it if there are sticky
whitish streaks on the dishes.
Clean up any rinse aid spilt during filling with an absorbent
cloth to avoid excess foaming during the next wash.
Only use branded rinse aid for dishwashers. Never fill the rinse
aid dispenser with any other substances (e.g. dishwasher
cleaning agent, liquid detergent). This would damage the
appliance.
Top up the rinse aid when the rinse aid indicator light on the
control panel illuminates.
It is possible to deactivate the rinse aid indicator light (see the
following instructions).
BR03
BR02
To deactivate the rinse aid indicator
light proceed as follows:
(the dishwasher must be switched off)
1. Press function push buttons 1 and 2 simultaneously.
2. While keeping the function push buttons 1 and 2 pressed
switch on the dishwasher by pressing the On/Off push
button.
The On/Off indicator light comes on.
At the same time, the indicator lights of push buttons
1 and 2 start flashing.
3. Press function push button 2, the corresponding indicator
light keeps flashing while the indicator light of push button
1 turns off. At the same time the rinse aid indicator light
starts to flash.
4. Press push button 2 again, the rinse aid indicator light turns
off, this means that the rinse aid indicator light has been
deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button.
To reactivate the rinse aid indicator light follow the same
process until the rinse aid indicator light starts to flash.
7
SO568
SO570

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents