GMC Hybrid 2006 Owner's Manual page 14

3. Turn the ignition key to LOCK while the light is
flashing. The light will flash for up to 30 seconds.
When the ignition key has been turned to LOCK, the
light next to the APO switch will stop flashing and
remain on. The engine will continue to run.
4. Connect your 120-volt AC electrical/electronic
device(s) to the outlets. If you must use extension
cords, be sure to use only UL
extension cords.
You can remove the key from the ignition at this point.
CAUTION:
{
Leaving children in a vehicle with the ignition
key is dangerous for many reasons. They
could operate the power windows or other
controls or even make the vehicle move. The
children or others could be badly injured or
even killed. Do not leave the keys in a vehicle
with children.
2-6
®
approved
If the system stops supplying 120-volt AC power
unexpectedly and the light next to the APO button starts
flashing, the system has detected an overload or ground
fault condition. To reset the system see "Resetting the
Short Circuit, Overload or Ground Fault Detection (GDF)
Circuit" later in this section.