Samsung SyncMaster 710T User Manual page 44

SyncMaster 510T / 710T / 910T / 711T / 912T / 701T
Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call
Information section or contact your
Symptom
No images on the Is the power cord connected
screen. I cannot turn properly?
on the monitor.
Can you see "Check Signal
Cable" on the screen?
If the power is on, reboot the
computer to see the initial screen
(the login screen), which can be
seen.
Can you see "Not Optimum
Mode","Recommanded Mode
1280 x 1024 60Hz" on the screen?
dealer.
Check List
Check the power cord connection
and supply.
(Connected using the D-sub
cable)
Check the signal cable connection.
(Connected using the DVI cable)
If you still see an (error) message
on the screen when the monitor is
connected properly, check to see if
the monitor status is set to analog.
Press Source button to have the
monitor double-check the input
signal source.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/XP/2000) and then
change the frequency of the video
card.
(Refer to the
Note: If the initial screen (the login
screen) does not appear,
the Service Center or your
You can see this message when the
signal from the video card exceeds
the maximum resolution and
frequency that the monitor can
handle properly.
Adjust the maximum resolution and
frequency that the monitor can
handle properly.
If the display exceeds SXGA or
75Hz, a "Not Optimum
Mode","Recommanded Mode
1280 x 1024 60Hz" message is
the phone number on the
Solutions
Preset Timing Modes)
contact
dealer.