Table of Contents
Advertisement
ChEVROLET ExPRESS VAN
The jack is located under the rear lounge inside the vehicle.
•
Loosen the wheel nuts before raising the vehicle.
•
Close the release valve on the jack.
•
Assemble the pump lever provided and insert it into the socket on
the jack.
C
•
Secure lever by turning it clockwise in the socket.
•
Position the jack under the appropriate jack point and raise the
vehicle by pumping the lever.
WHEEL SIMULATORS
The wheel simulators are installed by Airstream.
Installation Instructions:
1. Install single wheel liner over lug nuts in correct position for proper valve
stem and hand hole alignment.
2. Install hub cover over single wheel liner nuts, allowing lug nuts to protrude
through the attachment holes.
3. Install the jam nut/lug nut cover onto the lug nut exposed through the hub
cover.
4. Use the installation tool provided to tighten the jam nut/lug nut cover.
5. Store installation tool inside vehicle.
Removal Instructions:
1. Use the installation tool provided to loosen the jam nut/lug nut
cover.
2. Remove jam nut/lug nut cover.
3. Remove hub cover and single wheel liner.
NOTICE: For diagrams and additional information, see the original
manufacturer's instructions provided in your Airstream Owners Packet.
nOTiCE:
After the first 100 miles check that the simulators are tight
and secure to the wheels. If necessary, retighten. We recommend that the
wheel simulators are checked and inspected periodically to make sure
that they are tight and secure to the wheels.
Removing a Wheel
1. Do a safety check of your surrounding before proceeding.
2. Remove wheel simulators, if so equipped.
3. Loosen but do not remove all the wheel nuts with the wheel wrench.
4. Assemble jack and related tools.
5. Position the jack under the vehicle, using the locations listed in your Chevrolet
Operator's Manual.
6. Raise the vehicle far enough off the ground so there is enough room for the
spare tire to fit.
7. Remove all the wheel nuts.
C - 10
Advertisement
Table of Contents
