Philips TV User Manual page 13

Available menu items in case of the selected
and available Surround modes.
Surround settings
•
Test Start
•
Test Stop
Centre Volume*
• •
Balance
Rear Volume
•
3D effect
• •
Surround Mode
Surround settings
Test Start
Test Stop
Centre Volume
Balance
Rear Volume
3D effect
Surround Mode
*
'Dolby' 'Pro Logic' and the double-D symbol
trademarks of Dolby Laboratories.
Manufactured under license from Dolby Laboratories.
• •
• •
*
• •
• • •
• •
• • •
&
é
"
'
are
Surround settings menu
Select in the Sound menu.
Surround settings
The contents of the Surround settings menu depends on the available and
selected Surround modes.
Centre Volume control is available with Pro Logic and Dolby 3 Stereo modes.
See Surround Mode Chart on the following page and Installation/Setup menu,
p. 7 for further details.
Note: you can select only those surround modes which can be used with the
broadcasted signal.
The graphical representation of the speakers is displayed on screen when
controls are being changed or when in test tone mode.
The drawing on screen is updated according to the chosen setup and the
selected surround mode. Speakers which are active are highlighted.
In Dolby Virtual mode the graphical representation of the rear loudspeakers is
replaced by the symbol ®r.The menu item
of the 3D effect can be adjusted.
Note: if extra front speakers are connected and selected in the Setup menu, all
internal TV speakers produce centre sound. See Connect Peripheral Equipment, Extra
loudspeakers/Amplifier, p. 27.
Adjustment of the volume level of the loudspeakers
The menu item which only appears in Dolby*3 Stereo, Dolby Virtual
Test
mode or Pro Logic, enables you to have a reference of the internal and the
rear loudspeakers loudness.
Select ,
Dolby 3 Stereo Dolby Virtual
Select and press the OK key.
Test Start
A steady noise tone is switched sequentially through the available
loudspeakers, for 2 seconds each.This enables you to have a reference of the
loudness of each loudspeaker.
The loudspeakers activated light up in the screen graphic.
Select ,
Centre Volume Balance
selected adjustments.
Select and press the OK key when you have finished the
Test Stop
adjustment of the speaker levels.
With two extra front loudspeakers connected
To enhance the sound reproduction of your TV you may connect two extra
front loudspeakers via an external amplifier. See Connect Peripheral
Equipment, Extra loudspeakers/Amplifier, p. 27.
In the Surround modes, Hall and Stereo
should switch on your amplifier as in these modes the internal TV speakers
do not produce any sound.
Note: If extra front speakers are connected and selected, all internal TV speakers
produce centre sound in the surround modes Pro Logic and Dolby 3 Stereo. The TV's
internal speaker system can also be used with an external Amplifier for Centre
Channel surround sound playback. See the Connect Extra loudspeakers/Amplifier
section, p. 27, for details.
appears and the level
3D effect
or .
Pro Logic
, and alter the
Rear Volume, 3D Effect
is added to indicate that you
(+ amp)
Use of the menus
13