Using The Self-Cleaning Oven; Before A Clean Cycle; How To Set The Oven For Cleaning - GE JCSP42 Owner's Manual

Using the self-cleaning oven.

Wipe up heavy soil on the oven
bottom.
16

Before a Clean Cycle

We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the first
self-clean cycle.
Remove the shelves, broiler pan, broiler
grid, all cookware and any aluminum foil
from the oven.
The oven shelves can be self-cleaned,
but they will darken, lose their luster
and become hard to slide.
Soil on the front frame of the range and
outside the gasket on the door will need
to be cleaned by hand. Clean these areas
with hot water, soap-filled steel-wool pads
or cleansers such as Soft Scrub
well with clean water and dry.

How to Set the Oven for Cleaning

Press the SELF CLEAN LO/STD pad
once for a 4-hour clean time or
twice for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when
cleaning small, contained spills. A
self-clean time of 4 hours or longer
is recommended for a dirtier oven.
If a time other than 4 hours or
3 hours is needed, use the number
pads and enter the desired clean
time.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirty your oven is.
Press the START pad.
The door locks automatically. The display
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKED door
light goes off.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for the
gasket to remain intact. If you notice it
becoming worn or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is in
place and the oven light is off.
IMPORTANT: The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any
range. Move birds to another well
ventilated room.
® . Rinse
When this LOCKED door light is off, open
the door.
I
The words LOCKED or LOCK DOOR will
flash and the oven control will signal if
you set the clean cycle and forget to
close the oven door.
I
To stop a clean cycle, press the
CLEAR/OFF pad. When the LOCKED
door light goes off indicating the oven
has cooled below the locking
temperature, open the door.