Philips DVDR 80 Owner's Manual page 30

5 Connect the mains jack 4MAINS at the back of the DVD
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.
Press STANDBY-ON m on the recorder. 'IS TV ON?' will
6
appear on the display.
7
Switch on your TV and select the channel used for DVD/VCR
playback on your TV. Choose between channel 3 or 4.
How do I switch the Recorder between channel 3 and 4?
The factory setting is for channel 3. However, if you would like to
switch to channel 4, proceed as follows:
Hold 4 on the remote control while 'IS TV ON?' is displayed.
1
2 'C04' (channel 4) will appear on the display.
If you want to switch back to channel 3, hold 3 . 'C03' (channel 3)
3
will appear on the display.
After the installation you can switch between the channels only
4
during standby.
8
Switch your TV to the selected channel (channel 3 or 4). Use
therefore your TV remote control.
The menu for language selection will appear on the screen.
a I don't see a menu for language selection
b Check the cable connections.
b Change between channel 3 and 4 on the TV.
9
This TV channel number must be used in the future for DVD
Recorder playback.
Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.
18
?
Menu Language
Problem
English
Español
Français
Press OK to continue
Connecting the DVD Recorder
Initial Setup