Philips AZ 4000 Operating Instructions Manual page 10

XP AZ 4000/00-1 19-11-2001 12:10
Digital Tuner
The radio automatically tunes to a station
of sufficient reception. Display shows
during automatic tuning.
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press SEARCH
∞ or § briefly and repeatedly until you
have found optimal reception.
Improving reception
– For FM, pull out the telescopic aerial. Incline
and turn the aerial. Reduce its length if the
signal is too strong (very close to a
transmitter).
stereo
Display shows
received in stereo.
– For MW(AM)/ LW (some versions only)
the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the
aerial by turning the whole set.
5 To switch off the tuner, press POWER y.
Programming tuner stations
Store up to a total of 30 tuner stations in
the memory, manually or automatically.You
can also erase a preset station by storing
another frequency in its place.
Autostore
Automatic programming will start with a
chosen preset number. From this preset
number upwards, former programmed
tuner stations will be erased.The unit will
only program stations which are not in the
memory already.
10
Pagina 10
1 Press PRESET / ALBUM - or + once or
more to select the preset number where
programming should start.
Note: If no preset number is selected, default
is preset 1 and all your presets will be erased.
2 Press PROGRAM for more than
2 seconds to activate programming.
if FM station is Manual programming
1 Tune to your desired station (see Tuning
2 Press PROGRAM to activate
programming.
3 Press PRESET / ALBUM - or + once or
more to allocate a number from 1 to 30 to
this station.
4 Press PROGRAM again to confirm.
5 Repeat the above four steps to store other
stations.
Display: appears. Stations
available are programmed in order of
waveband reception strength: FM,
followed by MW (AM) and then LW
(some versions only).The last preset
automatically stored will then be played.
to stations).
Display: and a preset number
program
flashes.
Display: disappears, and shows
program
the preset number, waveband and the
frequency.