Opening/Closing The Monitor And Power Switch; Removing/Attaching The Protection Panel - Kenwood KVT-935DVD Instruction Manual

Opening/Closing the Monitor and Power Switch

Open the monitor
[OPEN/CLOSE] key
Close the monitor
Turn the power
switch on
Hold down the [Source] key more than
one second to turn it off.
• Do not touch the moving components when you are opening or closing the monitor. If done, you will get hurt.
• Do not try to open or close the monitor by hand.
• You can automatically open or close the monitor when you turn on or off the ignition key (see page 44).
• If the monitor movement is stopped by the shift lever or another obstacle when the monitor is opened, this movement is
canceled by the safety function. If an obstacle is pinched by the monitor when closed, the monitor movement is also
canceled by the safety function. If it has occurred, remove the obstacle and press the [OPEN/CLOSE] key again.
8 English

Removing/Attaching the Protection Panel

Remove the protection panel
Attach the protection panel
Place the right end of the protection panel onto
hooks and push it until clicked and locked.
Then, push the left end of the panel to lock it.
[Source] key
• Close the monitor first, then remove or attach the protection panel.
• After you have removed the protection panel, you cannot operate the receiver.
• After you have removed the protection panel, you can flash the burglar alarm lamp (see page 57).
Two hooks
English 9