Kenmore 415.16117 Assembly Instructions/Use And Care Manual page 8

CAUTION
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
• Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP tank
off.
• Do not leave grill unattended while preheating or
burning off food residue on high. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product. Follow instructions on General
Grill Cleaning and Cleaning The Burner Assembly to
prevent grease fires.
Main Burner Ignitor Lighting
s Do not lean over grill while lighting.
1. Open lid during lighting.
2. To ignite, turn IGNITION BURNER knob to
3. Push and hold ELECTRONIC IGNITION button.
4. If ignition does NOT occur in 5 seconds, turn the burner
controls off, wait 5 minutes, and repeat the lighting procedure.
5. Ignite other burners by turning knob to
6. If ignitor does not work, wait 5 minutes, then follow match
lighting instructions.
CAUTION
If burner does not light, turn knobs to OFF, wait 5
minutes, and try again. Always close valve during the 5
minute waiting period. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
Match-Lighting
s Do not lean over grill while lighting.
1. Open lid during lighting. Turn on gas at LP tank.
2. Place match into match holder (hanging from side of cart).
Light match, place into lighting hole on right side of firebox.
3. Push in and turn right knob to HIGH position. Be sure burner
lights and stays lit.
4. Light other burners by pushing knob in and turning to
position.
8 • 464321907 • 464322107
Sideburner Ignitor Lighting
Sideburner Match Lighting
Before Your First Cookout
• Light burners, check to make sure they are lit, close the lid and
.
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW. You should see
.
Hose Check
• Before each use, check to see if hoses are cut, worn or kinked.
HIGH
1. Top cover must be open when burner is operational.
2. To ignite SIDEBURNER, open sideburner cover.
3. Turn sideburner knob to
IGNITOR button.
4. If sideburner does NOT light in 5 seconds, turn knob to OFF,
wait 5 minutes, then repeat lighting procedure.
1. Open top cover.
Turn on gas at LP tank.
2. Hold lit match to any port on the burner. Push in and turn
sideburner knob to
stays lit.
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose
, push and hold ELECTRONIC
HIGH. Be sure burner lights and
HI
LO
Kinked
Hose