Insignia NS-LCD32-09 Faqs page 3

I have poor picture quality.
•
Make sure your cable connections are connected securely.
•
If you are receiving service from a cable or satellite provider, reception can vary by channel depending on the broadcast
power level of a given station. Contact your cable or satellite provider.
•
If you are using an antenna, the signal strength of the channel may be low.
Check the signal strength of the channel (Please note that the signal strength is only displayed on digital
o
channels):
Press MENU. The on-screen menu opens.
Press ^ or v to select Setup, then press > to enter Setup menu.
Press ^ or v to select DTV Signal, then press > to view Signal Level display.
Press EXIT to close the Signal Level display.
The UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to
o
obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower.
Getting good UHF reception can be more difficult than VHF.
If you're getting marginal reception of digital signals, both the picture and sound might freeze or break up to the
o
point that it's not watchable. If you're really on the fringes—either too far from a tower or with too many
obstacles in the way—you'll see a black screen that says "No signal."
Reception can vary by channel, depending on the location and broadcast power level of a given station.
o
•
The video cables you are using may be bad, try a new set.
I am missing channels or want to run an autochannel search.
•
It is possible that the Favorite button was pressed accidentally.
Press the Favorite button on the remote.
o
•
Make sure the channel is not blocked by Parental Controls.
•
Are you using a cable/satellite box, cable connected directly to the TV, or an antenna?
If you are using a cable or satellite box you must use the remote that came with that box to change channels.
o
Make sure you have the correct input selected to view channels via the cable or satellite box. For
example, if the cable or satellite box is connected via component cables please press input and select
Component 1 or Component 2 to view your channels.
Reception can vary by channel depending on the broadcast power level of a given station. Contact
your cable or satellite provider.
If you are using cable connected directly to the TV:
o
Try running an autochannel search:
OR
Try manually adding the channel:
•
If the signal level is Weak:
Make sure your antenna is connected securely to the TV.
o
Move the antenna around the room or close to a window.
o
Use a basic indoor set-top antenna designed to pick up both VHF and UHF.
o
OR
Use a set-top antenna that has a built-in signal amplifier.
OR
Use an antenna mounted on your roof or in your attic.
For more information about antennas and the available channels in your area, visit
o
www.antennaweb.org.
•
Press EXIT to close the Signal Level display.
•
Press MENU. The on-screen menu opens.
•
Press ^ or v to select Setup, then press > to enter Setup menu.
•
Press ^ or v to select Tuning Band, then press > to select Cable.
•
Press ^ or v to select Auto Ch Search, then press > to begin searching for channels. Your TV
memorizes all cable channels you receive.
•
Press MENU. The on-screen menu opens.
•
Press ^ or v to select Setup, then press > to enter Setup menu.
•
Press ^ or v to select Manual Channel Set then press > to enter Manual Channel Set menu.
•
Press ^ or v to select the channel.
•
Press ENTER to toggle between Not Viewable and Viewable.
3