Troubleshooting - Ariens 927067-10528 Owner's/Operator's Manual

PROBLEM
1. Safety interlock system is not
2. Fuel tank empty.
3. Discharged battery.
4. Poor connection between battery
Engine will
not
crank/start.
5. Spark plug wire loose or spark
6. Faulty electrical system.
7. Faulty engine.
1. Choke engaged.
Engine
2. Air filter plugged.
runs
rough.
3. Faulty engine.
1. Transmission bypass lever is
Unit does
not move
with engine
running
2. Faulty hydrostatic belt.
when using
forward and
reverse
3. Faulty transmission.
pedal.
1. Operator presence switch not
2. Faulty operator presence switch.
PTO or
3. Electric clutch connector is loose
mower blade
does not
engage or
shuts off. 4. Faulty PTO belt.
5. Faulty PTO switch, wires,
1. Engine oil level low.
Engine 2. Cooling system plugged.
overheats.
3. Faulty engine.

TROUBLESHOOTING

PROBABLE CAUSE
engaged or is faulty.
and battery cables.
plug faulty.
engaged.
depressed.
or disconnected.
connectors, or clutch.
1. Check safety interlock system
(see Safety Interlock System on
page 10).
2. Fill fuel tank.
3. Charge battery (see Charging the
Battery on page 19).
4. Tighten battery cables and/or
clean battery and battery cables
(see Cleaning Battery and Battery
Cables on page 19).
5. Connect spark plug wire or
replace spark plug. Refer to
Engine Manual for detailed
instructions.
6. Contact your Ariens Dealer.
7. Contact your Ariens Dealer.
1. Disengage choke.
2. Clean or replace air filter. Refer to
Engine Manual for detailed
instructions.
3. Contact your Ariens Dealer.
1. Disengage transmission bypass
lever (see MOVING THE UNIT
MANUALY on page 12).
2. Replace hydrostatic belt (see
HYDROSTATIC BELT
REPLACEMENT on page 20).
3. Contact your Ariens Dealer.
1. Depress operator presence switch
by sitting on seat.
2. Contact your Ariens Dealer.
3. Connect electric clutch connector.
See figure 9 on on page 16 for
connector location.
4. Replace PTO belt (see PTO BELT
REPLACEMENT on page 21).
5. Contact your Ariens Dealer.
1. Add engine oil. Refer to Engine
Manual for detailed instructions.
2. Clean cooling system. Refer to
Engine Manual for detailed
instructions.
3. Contact your Ariens Dealer.
GB - 22
CORRECTION