Lighting Pilot - MHSC 400BBVNV Installation & Operating Instructions Manual

BBV, SBV Series Natural Vent Gas Fireplaces
LIGHTING PILOT FOR THE FIRST TIME
APPROVED LEAK TESTING METHOD
ou may c eck or as leaks it t e ollo in met ods only
oap and ater solution
n approved leak testin spray
lectronic sni er
Never check for gas leaks with open
flame!
eck or as leaks in eac o t e ollo in locations
ipe rom t e as supply line connection to t e as valve
urner connections
ilot
ac oint or connection
The control has an interlock device that does not allow the lighting of the fireplace up to
the moment the safety device of the flame has not interrupted the gas flow. After that pe-
riod of time (when the magnet is closed), it is possible to start the lighting operation.
The gas control knob is designed to be operated by hand. DO NOT use any tools during
this operation. Damaged knobs may result in serious injury.
Depress and turn knob counterclock ise
position
Depress ully and old pilot as knob
nitor ill automatically i nite t e pilot
depressed or a e
pilot continues to burn
I t e pilot does not stay lit repeat teps
ield made oints
actory made oints
ll oints on valve and control body

LIGHTING PILOT

e electronic i
eep knob ully
seconds elease and c eck t at
and
OPERATING INSTRUCTIONS - MILLIVOLT
If using a soap and water solu-
tion to test for leaks, DO NOT
spray solution onto control
body.
NOTE: Remove any excessive
pipe compound from the connec-
tions. Excessive pipe compound
can set off electronic sniffers.
as s ut o valve
to pilot
P
L I
O
T
Figure 20 -
Pilot Position