Sanyo TLS-4024P Service Manual page 5

Maintenance Table
ASSY, BRAKE BAND
ASSY, LEVER BT (tape guide)
FULL ERASE HEAD
ASSY, ROLLER CLEANER
ASSY, GUIDE ROLLER
ASSY, MOUNTING INCLNE S
ASSY, MOUNTING INCLNE T
Tape path
ACE HEAD
system
ASSY, LEVER PINCH ROLLER
MOUNTING, LIFT PINCH
CAM, LIFT PINCH
GEAR, CAM PINCH
EARTH CHIP CYLINDER
COMPL, CYLINDER
ASSY, CYLINDER UPPER
ASSY, REEL SUPPLY
ASSY, REEL TAKEUP
GEAR, REEL S
GEAR, REEL T
Reel drive
PULLEY, REEL
system
SPECIAL, WASHER 2.4 X 6 X 0.25
COMPL, MOUNTING CLUTCH
BELT, REEL
MOTOR, CAPSTAN
ASSY, GEAR FRICTION
ASSY, BRAKE S
ASSY, BRAKE T
Brake
ASSY, BRAKE CAPSTAN
ASSY, BRAKE SOFT T
ASSY, LOADING MOTOR
DAMPER
COMPL, GEAR WORM
CAM, MAIN
SPECIAL WASHER 3.6 X 0.5
GEAR, WHEEL 1
Loading drive
GEAR, WHEEL 2
system
GEAR RELAY PINCH OPT
SLIDE, CRECENT
GEAR, LOAD S
GEAR, RACK FRONT
GEAR, RACK START
GEAR, PINON
BACK TENSION TORQUE
Performance FWD, REW TORQUE
check PLAY TORQUE
REV TORQUE
1. This table shows the maintenance for up to 8000 hours. After this, repeat from the start or the table.
2. For places with symbols such as
3. This periodic maintenace check table changes considerably according to the using conditions and environment.
4. Refer to the (POWER FAILURE/DEW/USED TIME) menu for the length of time the unit has been used.
5. As the life of parts may be shortened if foreign particles and dusts remain accumulated on the tape guides and rotating and
contacting poritions, clean if dirty.
6. Dusts and other foreign particles on the tape guides may also shorten the tape life and lower picture quality, therefore clean
throughly.
2000H 4000H
( ) and ( ), carry out checking and cleaning, aand replace if necessary.
– 5 –
: Cleaning : Confirmation
8000H
6000H
PB BACK TENSION TORQUE 25 ~ 50 g ⋅ cm
FWD, REW TORQUE ≥ 600 g ⋅ cm
PLAY 55 ~ 110 g ⋅ cm
REV 100 ~ 210 g ⋅ cm
: Lubrication : Exchange
Notes