Tool Assembly - Makita 5360-21 Operator's Manual

To reduce the risk of
tool before attaching or removing accesso-
ries. Use only specifically recommended
accessories. Others may be hazardous.
Removing the Bit Holder (Fig. 1)
Fig. 1
Bit holder
For Cat. No. 5360-21 only:
1. Hold the bit holder firmly and pull back red sleeve toward tool.
2. Bit holder will pop out of the spindle, hold it firmly.
Inserting the Bit Holder
1. Push bit holder into spindle turning until locked into position.
2. Remember to clean and lightly grease the spindle from time to time.
Inserting Drill Bit or Chisel (Fig. 2)
NOTE: Only use accessories with SDS shanks.
Fig. 2
Symbols
Dimple
1. Align the symbol with dimple on front of bit holder.
2. Rotate bit until the oval groove on the bit aligns with the symbol on
the tool.
3. While pushing in the bit, turn it slightly, if necessary.
4. Push the bit in completely.
5. Turn the bit holder collar so that the symbol
front of the bit holder. The tool should now be locked.
6. Push and pull on the bit to check that it is locked properly — it should
move slightly.
7. To remove bits and chisels, turn bit holder collar so that the symbol
aligns with dimple on the front of bit holder. Remove bit.

TOOL ASSEMBLY

WARNING!
injury, always unplug
Spindle
aligns with dimple on
Adjusting the Side Handle Position
1. Loosen the clamping screw slightly.
2. Pull the side handle forward and turn it to the required angle.
3. Fit the side handle into the nonslip mounting until it adjusts into place
and retighten the clamping screw.
Setting the Depth Gauge (Fig. 3)
Fig. 3
Drilling Depth
1. Loosen the clamping screw.
2. Slide the depth gauge rod backward or forward until it is set for the
desired depth.
NOTE: The drilling depth is the distance between the tip of the bit and
the tip of the depth gauge rod.
3. Tighten the clamping screw securely.
page 5