Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Midland Manuals
  4. Radio
  5. TITAN
  6. Operator's manual

Midland TITAN Operator's Manual

Fm multi-mode mobile radio
Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Enlarged version
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
1120 CLAY ST • NORTH KANSAS CITY • MISSOURI • 64116
PHONE: (816) 241- 8500 • FAX: (816) 241-5713
www.midlandradio.com
MON
A/D
SCAN
AUX
CH
PWR
/VOL
DN
MON
SCAN
PWR
CH
/VOL
DN
™
TITAN
FM MULTI-MODE MOBILE RADIO
OPERATOR'S MANUAL
MENU
UP
A/D
AUX
MENU
UP
08.2K3

Advertisement

loading

Related Manuals for Midland TITAN

Summary of Contents for Midland TITAN

  • Page 1 MENU /VOL operation. SCAN MENU /VOL ™ TITAN FM MULTI-MODE MOBILE RADIO OPERATOR’S MANUAL 1120 CLAY ST • NORTH KANSAS CITY • MISSOURI • 64116 PHONE: (816) 241- 8500 • FAX: (816) 241-5713 08.2K3 www.midlandradio.com...
  • Page 2 FCC RF EXPOSURE REQUIREMENTS 70-2358 External Speaker The FCC has adopted a safety standard for human exposure to RF to pins 4 & 6 energy. Proper operation of this radio under normal conditions results (required for in user exposure to RF energy below the Occupational Safety and Pin 3 Mic Hang-up Deluxe Head) Health Act and Federal Communication Commission limits.

  • Page 3: Important Safety Information

    Testing, alignment and service information are provided in the service transmitting whenever the TX icon is displayed on the LCD. Pressing manual for this model. Service manuals for Titan™ radios are the PTT switch on the side of the microphone normally causes the available from Midland Radio Corporation at the address shown on radio to transmit.

  • Page 4: Scan Button

    PRIORITY SCAN ESCAPE CONTROLS AND INDICATORS If the radio technician has programmed the radio for this function, the operator may press the “AUX” button to operate on the last busy POWER/VOLUME KNOB channel. Press the “AUX” button again to revert to priority scan with Press and hold for a few seconds for power on.

  • Page 5: Monitor Button

    MONITOR BUTTON 4. PRI monitor function is not available in this mode. If scan is Press and immediately release the MON button to M O N stopped, Add/Delete of Group B channels is available in disable the receive Coded Squelch function for Add/Delete mode.
  • Page 6 SENDING A MESSAGE (TRANSMIT) NOTES: appears slow it may be necessary to adjust the squelch to a 1. Press MON to deactivate the Coded Squelch feature. If your higher level. transceiver is equipped with the Midland Switched Hang-Up Box, “OFF HOOK SCAN STOP”...