Assembly - Craftsman 247.770990 Operator's Manual

ATTACHING THE BLOWER CHUTE
NOTE: The bag must be removed before installing the blower chute.
8. a. Grasp blower chute with one hand and slide locking rod on
mounting bracket with other hand toward engine. Use the end of
mounting bracket as leverage when sliding the locking rod. See
Figure 8.
b. Slip blower chute over rim of discharge opening and release
locking rod to secure chute in place, as in Figure 8.
c. Raise the nozzle height to the highest setting when using the
blower chute. Refer to nozzle height adjustment in the ADJUST-
MENT section on page 16.
NOTE: The bag/chute switch button attached to the mounting bracket
must be fully depressed by the tip of front tab on the blower chute or
engine will not start.

ASSEMBLY

A
9
B
B
Figure 8