Dolby Digital Or Dts Connection - JBL PowerBass PB12 Service Manual

PB12
Dolby Digital or DTS (or Other Digital Surround Mode) Connection
Use this installation method for
Dolby Digital, DTS or other
digital surround processors:
IMPORTANT: Make sure that
the LFE toggle switch on the
subwoofer is in the "LFE"
position. Use the line-level
input jacks for the Low-
Frequency Effects channel.
Connect these jacks to the LFE
output or subwoofer output on
your receiver or amplifier.
Note: If your receiver or
amplifier only has one
subwoofer output jack,
then you may connect the
subwoofer output on your
receiver/preamplifier to either
the left or right line-level input
on the subwoofer. It makes no
difference which jack you
choose.
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
9
Make sure that you have
configured your surround-
sound processor for
"Subwoofer On" or "LFE On."
The front left, front right, center
and rear speakers should be
set to "Small" or "Large"
depending on their size and
frequency response. Consult
your receiver's or processor's
owner's manual.