Chapter 4: Configure The Pcs; Overview; Configuring Windows 95, 98, And Millennium Pcs - Linksys EtherFast User Manual

Chapter 4: Configure the PCs

Overview

The instructions in this chapter will help you configure each of your comput-
ers to be able to communicate with the Router.
To do this, you need to configure your PC's network settings to obtain an IP (or
TCP/IP) address automatically (called DHCP). Computers use IP addresses to
communicate with each other across a network, such as the Internet.
Find out which Windows operating system your computer is running. You can
find out by clicking the Start button and then selecting the Settings option.
Then click Control Panel, and double-click the System icon. If your Start
menu doesn't have a Settings option, you're running Windows XP. Click the
Cancel button when done.
You may need to do this for each computer you are connecting to the Router.
Important: These instructions apply only to Windows 95, 98,
Millennium, 2000, or XP machines. For TCP/IP setup under
Windows NT, see your Windows manual. By default, Windows 98,
2000, Me, and XP have TCP/IP installed and set to obtain an IP
address automatically.
The next few pages tell you, step by step, how to configure your network set-
tings based on the type of Windows operating system you are using. Make sure
that an Ethernet card or adapter (also known as a network adapter) has been
successfully installed in each PC you will configure. Once you've configured
your computers, continue to "Chapter 5: Configure the Router."
12
Instant Broadband Series
™
EtherFast Cable/DSL Router with QoS and 8-Port Switch
®

Configuring Windows 95, 98, and Millennium PCs

1. Go to the Network screen by clicking the Start button. Click Settings and
then Control Panel. From there, double-click the Network icon.
2. On the Configuration tab, select the TCP/IP line for the applicable
Ethernet adapter. Do not choose a TCP/IP entry whose name mentions
DUN, PPPoE, VPN, or AOL. If the word TCP/IP appears by itself, select
that line. (If there is no TCP/IP line listed, refer to "Appendix D: Installing
the TCP/IP Protocol" or your Ethernet adapter's documentation to install
TCP/IP now.) Then, click the Properties button.
Figure 4-1
13