JVC KD-AR370J Service Manual page 12

3.1.4 Removing the side panel
(See Fig.4)
Reference:
Remove the front panel assembly as required.
(1) Remove the screw B and two screws C attaching the side
panel on the left side of the main body.
(2) Remove the side panel from the main body.
3.1.5 Removing the rear bracket
(See Fig.5)
• Remove the bottom cover.
(1) Remove the three screws D, three screws E and two
screws F attaching the rear bracket on the back side of the
main body. [For KD-AR370, KD-G320, KD-G424, KD-
G425, KD-G427]
(2) Remove the four screws D, three screws E and two screws
F attaching the rear bracket on the back side of the main
body. [For KD-G421]
(3) Remove the rear bracket.
3.1.6 Removing the main board
(See Figs.5 and 6)
• Remove the front panel assembly, bottom cover and side pan-
el.
Reference:
Remove the front chassis assembly as required.
(1) Remove the three screws D attaching the rear bracket on
the back side of the main body. [For KD-AR370, KD-G320,
KD-G424, KD-G425, KD-G427] (See Fig.5.)
(2) Remove the four screws D attaching the rear bracket on
the back side of the main body. [For KD-G421] (See Fig.5.)
(3) Remove the two screws G attaching the main board. (See
Fig.6.)
(4) Disconnect the connector
the main body and take out the main board with the rear
bracket. (See Fig.6.)
Reference:
Remove the rear bracket from the main body as required. (See
"3.1.5 Removing the rear bracket".)
1-12 (No.MA245)
CN501 on the main board from
B
C
Side panel
Fig.4
[For KD-AR370,KD-G320,KD-G424,KD-G425,KD-G427]
Rear bracket
E
D
[For KD-G421]
E
Rear bracket
D
Fig.5
CN501
G
Rear bracket
Fig.6
C
F E F
D
F E F
D
Main board
G