Related Manuals for Baby Trend 8166BC
Summary of Contents for Baby Trend 8166BC
- Page 1 Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Model #8166BC SAFAri babies Trend Nursery Cen ter Instruction Manual 08.06 Convenience through Innovation and thoughtful design...
- Page 2 • Before each usage or assembly, inspect product for damaged hardware, loose joints, missing parts, or sharp edges. DO NOT use Playard if any parts are missing or broken. Please contact Baby Trend Customer Service for replacement parts, repair or instructional literature if needed. DO NOT substitute parts.
-
Page 3: To Assemble Playard
1 Travel or Storage bag Figure 1-1. BEFORE YOU BEGIN: The Baby Trend Playard is designed so that, when properly setup, the fabric of the playard places pressure on the 4 top rails making them nearly impossible to unlock. This safety feature is activated when you push down on the playard floor to lock the bottom... - Page 4 WARNING: All top rails MUST be straight and locked in position or child may become entrapped and suffocate. See figure 9 and 10. 5. Place mattress in Playard with padded side up (Fig. 11). NOTE: DO NOT insert mattress if using bassinet feature. Go to bassinet instructions.
-
Page 5: Folding Playard
FOLDING PLAYARD 1. Undo the 6 hook and loop straps holding mattress from underneath Playard floor. (If mattress is not used in the bassinet). Remove mattress and set aside. 2. Grasp the center floor lock handle pushing down. Rotate the handle Rotate before counter-clockwise about 90 degrees and lift upward until handle is as lifting... - Page 6 To help prevent suffocation from entrapment, use only the mattress provided by Baby Trend ® . Never use additional mattress or padding. Never use plastic shipping bags or other plastic film as mattress covers not sold and intended for that purpose. Avoid...
- Page 7 TO ASSEMBLE YOUR BASSINET NOTE: Playard MUST be in a locked set-up position before installing and using the bassinet feature. CONTENTS (Fig. 1): 1 Nylon bassinet insert 4 Metal support tubes 2 (male) (2 female) ASSEMBLY 1. Insert the 2 female tubes into the two male tubes. (Fig. 2) 2.
- Page 8 TO ASSEMBLE CHANGING AREA CONTENTS (Fig. 1): • 2 Long curved bars • 2 Short bars with connector knobs • 1 Changing area fabric WARNING: Figure 1 Avoid serious injury or death: • Always use restraint belt to prevent falls •...
- Page 9 NOTE: Short bar with connector knobs should be facing inward. 5. Place connector knob prongs into holes located on corner pieces of Playard (Fig. 5). 6. Turn connector knobs counter clockwise to lock (Fig. 6). 7. Flip changing area to inside of Playard (Fig.7). 8.
- Page 10 HOW TO USE CHANGING TABLE RESTRAINT Place child on changing table, make sure hands and arms are clear of the restraint. Bring the restraint around the child's waist and clip the male and female ends of the buckle together. See Fig 1 2.
- Page 11 REMOVAL OF BASSINET REMOVAL 1. Remove mattress from bassinet (Fig.1). 2. Lift bassinet out of Playard (Fig. 2). The bassinet is now ready for storage. NOTE: Store bassinet and changing area with folded Play yard in carry bag. Figure 1 Figure 2 TO INSTALL TOY BAR Attach the toy bar to each end of the playard opposite of the...