Related Manuals for Baby Trend 8136BCC
Summary of Contents for Baby Trend 8136BCC
- Page 1 Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. Model #8136BCC DELUXE TREND NURSERY CENTER Instruction Manual 12.04 Convenience through Innovation and thoughtful design...
- Page 2 • Before each usage or assembly, inspect product for damaged hardware, loose joints, missing parts, or sharp edges. DO NOT use Playard if any parts are missing or broken. Please contact Baby Trend Customer Service for replacement parts, repair or instructional literature if needed. DO NOT substitute parts.
-
Page 3: To Assemble Playard
1 Travel or Storage bag Figure 1-1. BEFORE YOU BEGIN: The Baby Trend Playard is designed so that, when properly setup, the fabric of the playard places pressure on the 4 top rails making them nearly impossible to unlock. This safety feature is activated when you push down on the playard floor to lock the bottom... - Page 4 WARNING: All top rails MUST be straight and locked in position or child may become entrapped and suffocate. See figure 9 and 10. 5. Place mattress in Playard with padded side up (Fig. 11). NOTE: DO NOT insert mattress if using bassinet feature. Go to bassinet instructions.
-
Page 5: Folding Playard
FOLDING PLAYARD 1. Undo the 6 Velcro straps holding mattress from underneath Playard floor. (If mattress is not used in the bassinet). Remove mattress and set aside. 2. Grasp the center floor lock handle pushing down . Rotate the handle Rotate before counter-clockwise about 90 degrees and lift upward until handle is as lifiting... - Page 6 • SUFFOCATION HAZARD: To help prevent suffocation from entrapment, use only the mattress provided by Baby Trend ® . Never use additional mattress or padding. Never use plastic shipping bags or other plastic film as mattress covers not sold and intended for that purpose.
- Page 7 TO ASSEMBLE YOUR BASSINET NOTE: Playard MUST be in a locked set-up position before installing and using the bassinet feature. CONTENTS (Fig. 1): 2 Right corner supports 2 Left corner supports 1 Nylon bassinet insert 2 Long metal tubes 2 Medium metal tubes 2 Short metal tubes ASSEMBLY Figure 1...
- Page 8 TO ASSEMBLE CHANGING AREA CONTENTS (Fig. 1): • 2 Long curved bars • 2 Short bars with connector knobs • 1 Changing area fabric WARNING: Figure 1 Avoid serious injury or death: • Always use restraint belt to prevent falls (Fig. 1-1).
- Page 9 NOTE: Short bar with connector knobs should be facing inward. 5. Place connector knob prongs into holes located on corner pieces of Playard (Fig. 5). 6. Turn connector knobs counter clockwise to lock (Fig. 6). 7. Flip changing area to inside of Playard (Fig.7). 8.
- Page 10 REMOVAL OF BASSINET ASSEMBLY 1. Remove mattress from bassinet (Fig.1). 2. Lift bassinet out of Playard (Fig. 2). 3. Remove corner pieces and slide metal tubes from fabric sleeves (Fig. 3). 4. Separate tubes by pressing on snap buttons and pull apart. The bassinet is now ready for storage.